服务热线:

0556-6568000

What are the components of the cutting system of the bag making machine?

2019-08-08 14:34:54 0次浏览

Anhui Yinsheng Electric Equipment Co., Ltd. tells you that the bag cutting machine cutting system consists of a cutter, a length adjuster, an overrunning clutch, and wire bonding adjustment.

1. Cutter: It is the most important part of the system. It adopts a movable knife and a sliding guide. The floating mechanism is pressed by the spring, and the upper and lower knives can be adjusted. Among them, an adjusting screw is provided, which can be used to adjust the tightness of the cutter, and can well exclude the difficulty of cutting raw materials.

2. Bag length adjuster: The length of the bag is adjusted to control the length of the bag by changing the position of the link on the eccentric carriage, and the bag size is adjusted by tightening the hand wheel and the nut.

3. Overrunning clutch: The medium plastic overrunning clutch is an important part of the machine. Its quality and performance directly affect the error of the product length. However, in the course of use, due to the high working frequency, its life has a certain limit. If it is found that there is an error in the length of the bag during the production process (usually after half a year of continuous production), and the other faults cannot be solved, the clutch inspection and maintenance can be disassembled.

4. Adjustment of welding line and cutting line distance: The distance between the welding line and the cutting line is generally 5-10mm. Turn the hand wheel on the adjusting frame to raise or lower the beam roller to a certain distance to obtain the ideal cutting line. In order to facilitate the observation of the quality of the wire, the wire position of the single bottom wire can be adjusted to the outer end of the machine cutter. If the welding wire and the bottom thread are not parallel, loosen the fastening screw of one bevel gear and turn the handwheel to raise or lower one end of the beam roller. After the production is stable, lock the screw of the gear.

5. Welding knife adjustment method: Put a thin piece of paper on the support base and turn the large hand wheel in the body box to make the welding knife.

6. Automatic light control feeding device: The device is composed of servo motor, feeding rubber roller, light control louver, blind, photoelectric tracking machine and electric control wire. Its function is to keep the film feeding normally during the production process. When the machine is running, when the film feeding speed is too fast to cover the light control rays, the device will issue a command to stop the motor from rotating.